BMS End User Documentation

This document provides instructions for safe and effective use of the BMS in the HIGHDRA copter.

Getting Started

1. Installation:
   Place the 6 packs of BMS inside the copter. Ensure the BMS is securely placed inside the copter as per the manufacturer's instructions.

2. Activation:

   • Press the designated button on one BMS for 1s to power it on.
   • The LED indicator should light up when the button is pressed.
   • Activation is performed on all BMS packs, indicated by a orange LED. After 1s, the LED changes to green, indicating a ready to use copter.

3. Operation:

   • Only use the packs of a battery set it was supplied with (same color encoded plate, near the handle).
   • Do not use the HIGHDRA with with incomplete battery configuration.

Indicators

• Green LED: BMS is fully operating.
• Orange LED: BMS is in Precharge mode during activation.
• Red LED: Indicates an error. Refer to the BMS Interface for troubleshooting steps.

Safety Notes

• Always follow safety guidelines when handling batteries.
• Disconnect the BMS if any abnormal behavior is observed.

Additional Resources

• Battery Pack Data Sheet

FAQ

Q: What should I do if the red LED is on?
A: This indicates an error. Please check the BMS Firmware Documentation for troubleshooting.

Q: Can I replace packs with those of a different battery set?
A: No, only use the BMS with its designated battery set.

For further assistance, contact your support representative.